马达使用注意事项　Instructions

1.当你使用马达时，不可有束缚之物，如接着剂不要经过旋转轴流入轴承，妨害马达的运作。

2.轴的转动对马达之寿命可能有相反的效果，为了寿命的延长，请检查你的负载品是否依照规定，不可超负载，或轴端挂有妨害转动的物品。

3.制造成偏心之重幅射负载，有害马达之寿命。

4.请勿贮藏于四周高温或极端潮湿中，也请勿放置在腐蚀瓦斯中，会使马达效果降低。

5.马达请勿运转在周围高温与潮湿中。

6.电源正负极的马达端子上要焊锡时，烙铁温度340℃±40℃、加热时间3秒钟以内，不可使塑料变形，在工作中，让焊锡点流入马达或折断电线末端，这样会使马达功能衰退。

7.不可让马达轴卡住，当传入电力时，在短时间内会使马达过热，烧毁其附属品。
8.因工作人员缺乏技术，使马达遇说明书提及之事，或表面判断显然是过失时，是无法保证质量。

9.供应规定电力，确信在可测要求范围内。

10.滑轮或齿轮的安装，在压入时不要异常的加重。

11.安装马达之时，螺丝钉过长，会造成马达本身和转子间发生接触，会影响特性。

1. When you use a motor, not bondage thing, such as adhesives do not after rotation axis inflow bearing prejudice to the operation of the motor.

2. The axis of rotation of the life of the motor may have the opposite effect, for longevity, check whether you load goods in accordance with the provisions of, not ultra-load, or the shaft end prejudice rotation of items hanging.

3. Manufacturing the heavy radiation eccentric load, harmful motor life.

4. Do not stored at four weeks of high temperature or extreme humidity, do not place corrosive gas, causes the motor effects reduced.

5. The motor Please do not operation in the surrounding high temperature and humidity.

6. Power the positive and negative terminals of the motor to be solder, soldering iron temperature of 340 ° C ± 40 ° C, the heating time less than 3 seconds, not the plastic deformation work, so the the solder point into the motor or broken wire ends, this would allow the motor functionrecession.

7. Not to allow the motor shaft stuck, when the incoming power, motor overheating will make in a short time, and burned their accessories.

8. Due to lack of technical staff, the motor in case of manual mentioned things, or the face of it obviously is negligence, is unable to guarantee the quality.

9. Supply that power, sure can be measured within the requirements.

10. Pulleys or gears of the installation, in the press-fitting is not abnormal aggravated.

11. Mounting the motor when the screw is too long, can cause contact between the motor itself and the rotor, will affect the characteristics.